AMD BC-250 Microfit Holder / Clip

This assembly takes two microfit connectors and contains clips to keep them latched to the mating connectors on a BC-250 computer.

Prints without supports and tested in PETG. From user feedback, an outer brim and slower print speeds (at least on the non-bridge sections) can result in a cleaner, tighter fit on the connectors.

Please note that if your BC-250's connectors are heavily skewed due to poor assembly, this model might not work as is. Mine have a slight skew but still seat well.

Flush cut the existing latch off of your male connectors then press them (in the correct order and orientation!) into the print from behind (the side where you would press down the clip release). Do not use excessive force on the cables (ideally none), especially if you didn't make them yourself. Use a medium flat-head screwdriver or similar to gently press on the back of each connector until they click into the print and are inset by ~1mm.

If you need to disassemble it, I highly recommend sacrificing the print by cutting into each side. If the plastic is not too stressed during removal, you can likely reuse it even with the cut.