2010-2024 Toyota 4Runner 6.5" Speaker Adaptor for JL C2-650x
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I remixed the original to get a better fit for my JL C2-650x speakers in my 4Runner, and I stiffened the body a bit.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 105
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
I remixed the original to better fit in my 2024 4Runner for my C2-650x speakers.
The same adapter can be used for both rear doors and both speaker positions in the rear hatch. The only difference is the CCF ring for each location. The rear hatch location has a ton of room around it, so there's no issue. On the rear doors, the inner door card has a push pin just below the speaker, so some of the ring needed to be trimmed away to fit.
I used threaded heat inserts to hold in the speakers and the CCF ring instead of nuts. For the CCF rings, I used M3 inserts to better hold them together during installation. For the speaker itself, I used 8-32 inserts from McMaster (97171A160).
The goal with the CCF rings was to keep the CCF foam off the speakers. With that, the rings are designed for ResoNix CCF Strips, which are 1" tall, and with the thickness of the adapter, decoupler tape x2, and the strips, this puts the speaker ~3/4" away from the door card's speaker ring and squishes the foam by about 1/4".
Changed the speaker screw hole pattern to a 155mm diameter for the 650x speakers
Inner hole size is now 141.2mm
Outer hole size is now 165.1mm
Thickened the adapter to get the speaker closer to the door panel's grill opening
Created CCF Mounting Rings to keep the CCF foam off the speakers
Changed to heatset inserts 8-32 for speaker and M3 for CCF Rings (It's what I had on hand)
Reinforced all joints
Added a passthrough for the speaker wires