2010-2024 Toyota 4Runner 6x9" Speaker Adaptor for JL C2-690tx
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I didn't like how flimsy the off-the-shelf 6x9" adapters felt, so I designed my own.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 154
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
I made my own adapters to better fit my use case on my 2024 4Runner for my C2-690tx speakers.
The same adapter can be used for both front doors. The only difference is the CCF ring for each location. On the front doors, the inner door card has a push pin just below the speaker, so some of the ring needs to be trimmed away to fit. I used a Dremel with a cutoff wheel and sander to trim the ring and make it fit.
Threaded heat inserts were used to hold in the speakers and the CCF ring. For the CCF rings, I used M3 inserts to better hold them together during installation. For the speaker itself, I used 8-32 inserts from McMaster (97171A160).
The goal with the CCF rings was to keep the CCF foam off the speakers. With that, the rings are designed for ResoNix CCF Strips, which are 1" tall, and with the thickness of the adapter, decoupler tape x2, and the strips, this puts the speaker ~3/4" away from the door card's speaker ring and squishes the foam by about 1/4".