Sliding system for hanging outdoor lights from a metal wire
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Detachable hanging system for patio lights. See also my solar lantern balls project here.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 32
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a small follow-up on my own 'Solar lantern balls' post over here:
The little lanterns were much too close together on the wire for my taste, so I soldered them onto a new wire at the correct intervals. Outside on the patio, I stretched a metal wire from which I hung the lanterns. At first, I had secured them with zip ties. But after a few seasons, this became a bit impractical when I wanted to store the entire string periodically (in the winter, for example) or take it apart for repairs (some LEDs just break; in such cases, I solder in a new one from another set and turn it back into a fully functional string).
That’s why I designed a simple (40 mm long) bar that can be pressed onto the metal wire. Two sliders on either side hold the wires from the little lanterns in place. To prevent the wire from sagging between the lights, I use the smaller version with the short 10 mm bar.
Since I was already working on it, I also designed a small bracket through which a zip tie can be threaded to mount the solar cell on the (80 mm) downspout. This way, the unit can also be quickly removed for maintenance or off-season storage.