Xshot Trace Fire ZB 30 conversion Kit

( This is not a real firearm this is a cosmetic kit for a TOY. This toy is recommended for ages 14+. As always eye protection should be worn when playing or using gel balls, foam dart, or plastic bb toys )

Hardware

3, 1in 10-32 screws

3, 1 1/4 in 10-32 screws

4, 3/8 in 10-32 screws

1, 10/32 Hex Nut

20, M4 20mm screws

6 M4 10mm screws

2 M6 45mm screws

1, Tube of some sort

For the tube I used a 12 inch copper pipe with an outer diameter of 22mm just to make sure it is thick enough so that you can friction fit it on the inside of the orange muzzle on the trace fire. Some tape is also required to secure the tube of your choice in place inside the barrel. On the inside of the 3d printed barrel you will see there is one area that is thicker than the other parts that is where you should put your choice of tape on your tube of your choice. Also on the barrel it is important to screw in the 20mm M4 screws through the holes 1-2 times before assembling the barrel. That way the tolerance is a bit looser and is easier on the screw and your wrist. ( I circled this step in the images above )

Battery Door

The space where you can store a battery is now bigger! To assemble the battery door, align the door with the two 10-32 3/8in screws with the hole in the shell of the trace fire and just screw them in. ( I circled this step in the images above )

Operation

Reloading is the same as the original X Shot Trace Fire just refill the clear plastic magazine that comes with the X Shot trace fire and flip the blaster upside down. The power dial is covered up by the rear iron sight but I assume that adjusting your power mid game isn't really an issue most of you will have.

If you have any questions, want to inform me of anything about this build, or want to send photos of your build please email [email protected] 

Thank you