Pi Zero Official Lid Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Here's a case for use with the Pi Zero Official Case lids. I wanted to make use of these spare lids for the official…
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 68
- Wydruki
- 2
- Wyświetlenia
- 494
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Here's a case for use with the Pi Zero Official Case lids.
I wanted to make use of these spare lids for the official Pi Zero case, so here's a fancy case that fits the lids. The lid just snaps on and the fit is really close to the original.
There's no SD-card slot but feel free to remix it or ask if you'd like a hole for the SD-card slot, since it can be awkard to get the Pi out otherwise to change the card.
Printing at 0.2mm layer height is fine, but using adaptive layer height will give a slightly closer fit.
No supports required for printing, there should be enough space for most Micro-USB and Mini-HDMI cables to fit even with some sagging on the top of the ports.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
25%
Filament: Amazon's cheapest PLA PLA Grey How I Designed This ===================
This was designed through scanning the lid with a structured light 3d scanner, importing that into Fusion 360 and from there I used the lid scan's mesh to figure out how to get everything to fit.
Category: Electronics