1 / 1
Scleral lens/hard contact lens station V2 — zdjęcie 1

Scleral lens/hard contact lens station V2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Small station I use for inserting/removing my scleral lenses.

Ocena
0 / 5
Polubienia
0
Pobrania
6
Wydruki
0
Wyświetlenia
79
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Version 2 of my simple station for the insertion/removal of scleral/hard contact lenses, designed for function over form.

Cut outs at the back are sized for:

  • Lens Plus solution 360ml

  • Bio True 300ml

  • 2x Boston Advance Cleaner 30ml

  • 4 x hard lens removal tools (JB White from Amazon),

The post is intended to make it easier to fill your lenses, put your inserter in the top and fill.

There is a drain channel along the front edge with holes at either side - I use this on a draining board.

Make sure to keep this very clean, and reprint it periodically given what it is - pay particular attention to the inside of the inserter post when cleaning.

Unlike the previous version, layer height is a consideration when printing because of the newly added slope towards the drain channel, at larger layer heights this resembles a set of steps rather than a smooth slope.

This is around a 7hr print on my Centauri carbon at 0.16mm in PLA, around 204g of filament - print with the base on the build plate.

Tagi