STLink-V3Minie CASE
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a case I designed for the STLink-V3MINIE programming tool, featuring a 2.0mm pitch terminal to break out the pin
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 79
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Description
This is a custom enclosure designed for the STLink-V3MINIe programming tool. It features a 2.0mm pitch connector/terminal to break out the essential pins, making it much easier to connect to your target boards during development.
If you are tired of dealing with the fragile bare board of the V3MINIe, this case provides excellent protection while maintaining full functionality.
Hardware Required (BOM)
To assemble this, you will need:
1x STLink-V3MINIe programmer
1x 2.0mm pitch terminal/connector (2 row x 5 pin)
No screws required!
Print Settings
Material: PETG or PLA
Layer Height: 0.2mm
Infill: 30%
Supports: No supports needed
Perimeters: 3~4 walls
Assembly Notes
This design features a clever, screwless interlocking mechanism using end-caps. Follow these steps to assemble:
Sandwich the Board: Place your STLink-V3MINIe inside the Top and Bottom covers, aligning them together.
Secure the Pins: Slide the PinHolder cap over the 2x5 pin terminal end to lock that side of the case.
Secure the USB Port: Slide the Usb-c Holder cap over the Type-C port end to fully secure the enclosure.