1 / 8
(TO BE REDONE) Castle Castings Classic WW2 Siren — zdjęcie 1
1 / 8

(TO BE REDONE) Castle Castings Classic WW2 Siren

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

!!! READ BEFORE PRINTING !!!

DISCLAIMER: This model is currently in a prototyping phase. More information below, but I am currently redoing this model with a DE31-00073A Samsung Microwave motor, so it's gonna be bigger and more accurate. Print this version if you want!

It's finally here, and with some new modeling style used for it.

My classic WW2 Castle Castings air raid siren has finally been finished, after weeks of designing, and then starting over all over again after switching to Fusion 360. This might be my most simple real siren I've designed, but it's good.

Parts you'll need

Is this tested?: Yes. If you decide to print this and something doesn't work or for some other reason something messes up, you and privately DM me so we can talk about.

Assembly Instructions

  1. Print out all the parts in your desired filament. Motor cover is recommended printing with supports, tree supports specifically.

  2. Take your two 280 micro DC motors and line their wire terminals up, so you can pass 2 wires through the holes on the terminals to save space and wiring. Do this for both sides.

  3. Once you have your motor assembly made, thread the wire ends through the hole on the motor cover piece and align the wire with the little notch inside of it. Then, push the motors through so both motor shafts are sticking out on both sides.

  4. Take your stators, and put a little bit of double sided tape or glue of any sort and attach it one of the motors sides. Attach it directly to the motor, not onto the motor cover unless you must. Do this for both sides.

  5. After you've done step 4, press fit your rotors onto the shafts of each side. Spin the rotors and apply pressure in the opposite sides of places that the rotor scrapes on. This is optional / unnecessary as long as you have no scraping, or it is very very minimal.

  6. After you've done all the steps, you can hook it up to a power source! 9V Batteries or 12V power sources are good, but use a speed controller whenever you can, since you don't want to overvolt or overpitch the siren.

Final Words

I may or may not redo this design in the future when I'm better at designing in Fusion 360, so it's bigger and uses a microwave motor. I would use either a DE31-00029H or DE31-00073A. I'm not sure I'm gonna be doing this yet, but I might.

I hope you enjoy my siren models and hope you have fun making them. If you've made this model, please post a make with pictures, I want to see how well you did! ;)

Tagi