Insinkerator High(er) Flow Sink Strainer Garbage Disposal
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple, easy to print, high(er) flow sink strainer for Insinkerator garbage disposals. Designed for Badger 500.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 84
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is designed to be printed in ASA. Dumping boiling (or near-boiling) water down the drain is 100% going to deform PLA, and will likely deform PETG as well. You have been warned.
I was tired of dealing with a low-flow sink strainer that was constantly getting full of crap. But I didn't want to leave the drain open for utensils and eggshells to fall down. So I designed a high-flow strainer to alleviate the annoyance of a slow draining kitchen sink, but that still catches the big stuff and stops it from going down the drain.
Print in ASA.
Recommend printing with 100% infill.
Insinkerator Model Badger 500-4. Diameter of sink opening is approximately 84-85mm. Model measures 84.5mm in diameter, printed part measures 84mm in diameter.
Largest hole opening is 5mm, smallest hole opening is 2.5mm. Center hole goes through to allow flow if the strainer is too full.
Open area (full circle area minus area of plastic with holes, divided by full circle area) is approximately 31%.