ZuluSCSI Laptop Blaster PowerBook caddy
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Caddy for a Rev >=2026a ZuluSCSI Laptop Blaster to make it fit in a PowerBook 1xx drive cage
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 18
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a caddy/carrier for the ZuluSCSI Laptop Blaster SCSI hard drive emulator, revision 2026a or later, for use in a 100-series PowerBook. Rev 2026a moves the 50-pin connector to the underside of the board so that it fits every PowerBook, and this caddy model is intended for use with a board of that design. It is compatible with 100-series non-Sony-designed PowerBooks, and might be compatible with other models (the Duos, 520/540, and 100), but I don't have the ability to test those. To assemble, simply set the ZuluSCSI on the caddy bottom, line up the holes on the top, and press together. The complete assembly is the same size as a SCSI hard drive, and the caddy securely holds it to the body of the PowerBook.
The caddy prints well at 0.15mm layer height in your preferred plastic. Print with the sides that have crossbars facing the build plate. Note that the bottom has small cutouts for the drive pegs in the PowerBook chassis (these often break so you might not have them), so enable supports on the build plate and pull out the supports before you install it. If you don't have these holes, you can leave the supports in, but you may want to put some electrical tape on the drive cage just in case the caddy slides (it shouldn't).
FreeCAD sources are included, and the model is fully parameterized with values set in the separate spreadsheet file.