Flashforge Creator 5 Waste Ramp V3 - Rear Purge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Basically the same ramp as the V2 but now with a handle! And mirrored!
- Ocena
- 4,857 / 5
- Polubienia
- 86
- Pobrania
- 576
- Wydruki
- 7
- Wyświetlenia
- 2913
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Key Improvements & Updates
Zero Base Collision: Designed to match the exact height of the hotbed's underside spacers. It will not collide with the bottom of the printer if you accidentally leave it on after purging.
Updated for Rear Purging: Following recent updates, both the Standard and Pro models now purge at the back of the plate. The included files are set up to accommodate this rear purge location for both versions.
Alternative: If you prefer using the original V2 ramp, simply load that file into your slicer, right-click, and mirror it along the X-axis to fit.
Enhanced Clearance & Fit: Features a more secure fit and improved fan clearance.
Ergonomic Grip: Added a new handle designed to make grabbing and removing the ramp easy from either side.
Fully Rebuilt in FreeCAD: Migrated from Fusion 360 and completely optimized from the ground up.
Requires (6) D6x3mm magnets
Tip: Don't forget to apply foil tape to the ramp to prevent filament from sticking!