stiletto
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3d printed leg for a end table or night stand
- Ocena
- 0 / 5
- Polubienia
- 26
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 414
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Public Domain
This is the next design I reworked for printing. These legs use less than 1 kg to print. The tabletop is a little homage to mid-century modern. Look at the astro model page to understand where I started with this series. The ceramic version warped in the firing, something I never thought about coming from a woodworking background. Lots of learning curves, the biggest hurdle for me is glazing. Added a pic showing the warping and a four-leg version.
Print settings for photographed model using PrusaSlicer-2.3.1 based on Slic3r:
0.30mm DRAFT Infill: 20% Generic PETG
(3) - stiletto_leg_section_1
(3) - stiletto_leg_section_2
(3) - stiletto_leg_section_3
0.30mm DRAFT(modified) Infill: 100% Generic PETG
(3) - stiletto_threaded_rod_to_table_top_connector
(3) - stiletto_dished_washer
(3) - stiletto_glide
Hardware list:
(3) 1/4-20×21.5” threaded rod
(6) 1/4-20 hex nuts
(3) 1/4” washers
(9) 1-1/4” pocket hole screws
Tabletop router templates and a pdf for a paper connector layout are included.