Chevy GMT400 Passenger Vents
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Vents for the center and passenger side of the Chevy GMT400 trucks and SUVs
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 188
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
Following a request on the page for my driver's side vent, I modeled and printed the rest of the vents for my 1988 GMT-400 chevy truck.
You can use these to replace broken vents (all my vanes are disconnected from the controls) or just add flair to a cool old truck!
They should work in any Chevy truck or SUV from 1988 to 1994, the "Early OBS" style with the square dash (as seen in photos)
These do not have moveable air vanes, but feature a Chevy bowtie logo that serves as an air splitter
Removing the vents from the truck is easy, the center panel just pops off, and the passenger panel requires two screws in the glovebox to be removed
The vents themselves are held in by a metal clip. You will need this clip for the new vents, so don't lose it!
The vents print face-down, and require the control dial to be glued into place.
The dial on these new models is slightly thinner, but it can still be used for the old model
I highly recommend printing these in PETG or something more temperature resistant, PLA will likely soften and deform in a hot car or with heat on high.
My passenger vent was a tight fit, but the vent frame was rather bent, so yours might be loose. Let me know if you run into any issues!
You can find my driver's side vent here: https://www.printables.com/model/1078893-obs-chevy-driver-side-vent