Radxa Cubie A7S Snap-fit Case (UNTESTED)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
10 minute case design challenge. Place the board inside and then push the two halves together. The design is untested.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 197
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Radxa's STP model of the A7S was used for dimensions, so this model should theoretically work.
Note: Radxa's STP does not include the SD card slot, so my original model did not include a cutout for that. An updated version of the bottom half has been uploaded with a simple cutout that goes all the way through the bottom for it. The cutout dimension is based on reference images of the board. The Printables model images does not reflect this modification, but it does appear in the updated model.