1 / 9
Husqvarna Vitpilen 701 Lamp Bucket Fairing — zdjęcie 1
1 / 9

Husqvarna Vitpilen 701 Lamp Bucket Fairing

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Cafe-Racer-esque light fairing. No modification to lights or bike needed.

Ocena
0 / 5
Polubienia
0
Pobrania
10
Wydruki
0
Wyświetlenia
120
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial

I made a cafe-racer style bucket lamp mod for the Vitpilen (and Svartpilen ?) 701 using the original light and minimal hardware.

No permanent alterarions to bike or lights needed!

Check for local laws before putting it on you bike. Use at own risk.

IMPORTANT

Do NOT use PLA/PETG/ABS etc. !

This part forms part of the new bracket holding your 450€ headlight. You so not want it to split or rattle apart during installation or riding your oh-so-smooth 701. I recommend PPA-CF (or PPS-CF)due to its outstanding layer adhesion. Print with thick walls.

PARTS NEEDED

  • Original hardware from your lamp/bike. (3 screws holding the light to the bracket)

  • 2x M6x25 (or longer)

  • 2x M6 Nylon-Locknut,       alternatively 2x M6 Nut with Loctite

  • Spraypaint (optional but highly recommended)

  • 1 Ziptie (to replace the original on the bike)

INSTALLATION

Print the part and sand it properly. Double check that the inside is well sanded where the light will screw in. I even added a little grase there too. The light fits quite snug and is very hard to remove!

Drill out the 4 Screwholes and check that they fit.

The rest is self explanatory:

(Optional) Paint the Bucket.

Insert the M6 Nuts from the inside. If needed secure them in place (superglue or something). Do not glue the threads.

Take off the light from your bike using the 3 screws. (One is behind the lamp below the spedometer)

Put the Lamp in the bucket and secure with the original two screws. Cable should come out the back hole. Put the little rubber peace onto the cable now, or youll forget.

Plug cable back in and close the hole with the rubber piece. Intsall the ziptie on the rubber piece.

Use the 2 M6 screws and the remaining original one to secure the lamp back on the bike. Take note of the angle of your lights. It should be perpendicular to the ground when you are sitting on the bike.

unfortunately I cannot perform any alterations to the part because it was designed with Creo and I do not have a liscence any longer.

Tagi