1 / 1
Peg Perego Gator Wheel Hub Adapter to Harbor Freight 13" Haul Master Pneumatic Tire — zdjęcie 1

Peg Perego Gator Wheel Hub Adapter to Harbor Freight 13" Haul Master Pneumatic Tire

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This wheel hub adapts a Peg Perego rear drive to a 13" Harbor Freight Haulmaster tire.

Ocena
0 / 5
Polubienia
1
Pobrania
8
Wydruki
0
Wyświetlenia
79
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I have used as low as 30% infill, and standard PLA. Seems to be plenty strong enough, even after upgrading to an 18V battery system. 

Working on a dualie version, super slim adapter, as well as one that reverses the position of the hub. Stay tuned.

____

This wheel hub adapter a Peg Perego rear drive to a 13" Harbor Freight Haulmaster tire.

It requires the following hardware:

2EA - Shaft Bushings (in my library)

10EA - minimum 2" long, but not to exceed 3" bolts. I've found using either: 5/16"-18x2" or M8-1.25x50mm fits the existing HF wheel hub.

10EA - compatible washers

10EA - Nylon locking nuts that match the thread bolts. 

10EA - Non locking nuts with the thread of your choosing. 

____

  1. The first step is to remove the existing bolts from the HF wheel and replace them with your longer version. 

  2. Do this ONE BY ONE. Remove one bolt and washer assembly, insert new longer bolts with the flat washer, and locking washers. Then fasten using your new non locking nuts. If you don't do this one by one, you'll have to deflate the inner tube and align the bearings inside  the wheel again. 

  3. After replacing the bolts, mount the hub with the bushing (separate model in my library) to the longer bolts which now act as mounting studs. 

  4. Spin the new locking nuts with the washers and tighten down the hub.

  5. Mount onto your gator and enjoy. 

____

Existing drive shaft is too long.

You can either:

Cut the existing one down to proper length. Or use a 12mm aluminum rod, cut down to size, then thread appropriate ends on. I have found that McMaster# 4634T37 works great in 3 or 6 feet configurations. You should cut the rod down to 30-1/4" which will clear through the Gator and through the Harbor Freight wheels.