Destiny Ghost Extruder Spinner

Custom spinner for my MK3/S extruder using a 8x3mm magnet. I printed with black and silver PLA.

I modeled the basic shape by tracing an in-game Destiny 2 screenshot taken when Ghost was talking to me, tweaked the outline to give it appropriate wall thicknesses for a 0.45mm extrusion width, then made the backing part to suit this application. There is a small 0.2mm deep ~8mm diameter ring in the center of the back to help locate the magnet when you glue it on. The colored part is 0.4mm high to allow for two layers at 0.2mm so the first lines with the fresh color aren't visible.

Print instructions

Please make your own gcode based on your preferred print temperatures and material-specific settings.

Top/bottom fill pattern: Archimedean Chords
Layer Height: 0.2mm

In the generated gcode: Manually add a M600 command at the end of the z=2.00mm layer to prompt filament change, and add both M104 and M109 commands as desired just before the M600 if the second color requires a different temperature. If using 0.2mm layer height, these three commands can go just after

;AFTER_LAYER_CHANGE
;2.2