Funko Pop Wall Stand - 3M Command Strip or Screws - No Supports - Snaps together/No Glue
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Easy to print and assemble wall stand for displaying a Funko pop or other items. Mounts with screws or commands strips
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 67
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Small wall mounted display stand used to showcase a Funko pop or other small item.
The riser is printed horizontally, separate from the base, and snaps in. This eliminates weaker layer adhesion issues when printed upright. Two round 'mouse ears' are included in the riser model, to prevent curling, and need to be clipped off before assembly. To assemble, slide the grooved part of riser into the stand platform base until it snaps. If you want to release the riser, insert a fingernail, paperclip, etc and pull the snap edge down and pull apart.
The stand can be mounted with medium command strips, screws, or other adhesives.
For velcro command strips (aka 3M picture handing strips) only the stand and riser need to be printed, the depth on the back of the riser is set to just hide a pair of velcro strips after mounting. Attach the pair to the back of the riser/stand pair and mount per 3M's instructions.
For regular command strips, print out the Command Hanger. Put the strip on the non-hook side of the Command Hanger starting at the offset and press the command hanger to the wall (press for 60 sec). Then attach the riser/stand pair by sliding it over the Command Hanger. Be sure to leave the top edge of the Command Hanger free so it can fit into the upper lip of the riser.
For thin / clear command strips, print the Flat Hanger and attach as above. Clear strips are much thinner and need to attach without the gap that hides regular strips. The Flat Hanger can also be used with other adhesives (i.e. hot-glue, etc.)
For screws print the Screw Hanger, screw it to the wall, then attach as above. Most countersunk M3/#4 screws (or similar) should fit. Note the head of the screw needs to recess into the Screw Holder to allow the riser/stand pair to slide over.
I recommend dry fitting everything before hanging. Substantial elephants foot (over extrusion on layer 1) may need to be trimmed off for a good fit.
I hope folks find this useful, please comment with ideas or issues.