Smallrig pads for Smallrig crab clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rubber Pads for Smallrig clamp.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 89
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a replacement pad for a Smallrig crab clamp with 1.4Inch and 3.8Inch Thread: 2058 designed to print with TPU 95a. Its a bit trickier than PLA and needs drying and tests for temperature. My settings with a Bambu a1 were as follows:
Generic TPU + following changes
Nozzle temperature= min 210 Max 230
Cool plate Initial layer 35. other layers 60
Nozzle Initial layer 230 Other layers 240
Max Volumetric speed 7.2
Wall loops 3
I also slowed the speeds down to 25-30
I still had a little issue with stringing but i think that was the temperature and humidity in the room.
They pads fit very well and work perfectly.