Girls Frontline 2 Acrylic Spring Picatinny Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Takes a GFL2 acrylic character spring and turns it into a picatinny adaptable one.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 56
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial
Requirements:
1 M4x28 (or larger, but preferably 28/30mm) bolt
1 M4 hex nut
This is a pair of files meant to be used to take a Girls Frontline 2 acrylic spring and replace its provided mount with one that can be used on standardized picatinny rails without the need to glue any pieces permanently. Was printed originally with a 0.2mm layer height and supports only where the part touches the plate.
Printing:
Printed originally with a 20% infill and a 0.2mm layer height. Align the 2 files as shown in the second image in your slicer software. You'll have to add a pause in the slicer settings to just before the hole in the small part for the nut before it closes. At this point, insert your M4 hex nut into the part, then resume printing.
Installation:
Remove the spring from its provided mount (tilt it at an angle and pull on it with medium force, it should remove without issue). Align the tail of the spring (as pictured) to the inner hole at the bottom of the ringed section of the holder. Push down on the spring, it won't go all the way down, but on the opposite side of the tail use something like keys or a thin screwdriver to push the bottom coil of the spring down into the indented section until it snaps into place. When it is in place, shake the holder progressively harder to confirm the acrylic spring will hold into place safely without popping off.