Lee Challenger Right-Side Case Kicker v1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Right-side output case kicker for the Lee Challenger Sigle Stage Press. Allows for long cartridges.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 194
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Case Kicker that ejects to the right, and kicks at the end of travel to allow for longer cartridges. Interacts with the Press handlebar, so the handlebar must be completely vertical when in the up position. Decapping Primer ramp included, as the Lee primer arm will cause the case to bind.
Case kickers speed up the process and quality of life for the reloader. My setup requires case access from the right, all the other kickers load/eject to the left. Figured others could use this too.
Two versions included. 3mm screw and #6 screw.
Hardware needed:
Zip Ties
Rubber band
M3x+20mm screw or #6 x +3/4" screw.
Instructions:
Screw the kicker, mount, and foot together. Ziptie the mount to the left side of the press' front column. Loop rubber band around front notch on kicker, then feed the rubberband around the front of the column and around it to the back, feed UNDER the kicker and attach to the rear peg of the mount. See pictures.
Print settings:
Filament: PLA/PETG/ASA/PA
3 perimeters
30% infill
Troubleshooting: If the kicker binds on the ram, slide the mount higher up the column.