Remix of "Even lighter (ultralight) Elegoo CC Centauri Carbon toolhead cover" Version 3 (25 grams!)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 25.4 gram print head cover which will improve print quality and reduce VFA.
- Ocena
- 4 / 5
- Polubienia
- 25
- Pobrania
- 100
- Wydruki
- 1
- Wyświetlenia
- 826
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATE: I noticed the top cross bar created a bit of pressure against the snap-ins and would dislodge the fan over time. I trimmed up the cross bar to better fit and secure the cover. If you have already printed it and noticed an issue, shaving off a bit of material with a blade should do the trick.
This is a 25.4 gram print head cover which will improve print quality and reduce VFA.
I removed some excess material from the original, removed the screw holes so you can just snap in the fan for toolless installation. Just tilt the top of the fan in first (see photo), align to the mounting nubs and snap in the bottom. Reverse the install process to remove the fan.
The whole head cover is toolless in fact, instead of screws i used hemispheres which snap and hold well and will allow the cover and fan to detach from the head in an emergency just like the original.
I have not had a single issue in nearly 500 hours of printing. Enjoy!
