1 / 4
Baratza Encore burr holder - larger opening and full outer wall — zdjęcie 1
1 / 4

Baratza Encore burr holder - larger opening and full outer wall

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Larger top opening and full outer wall (v4.2 and v6.1) and new retention shelf design (v6.1).

Ocena
5 / 5
Polubienia
3
Pobrania
30
Wydruki
0
Wyświetlenia
91
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Modification Summary:

  • Increased the size of the opening where the hopper and burr holder mate (v4.2 and v6.1)

  • Filled in gaps to make a solid continuous wall (v4.2 and v6.1)

  • Changed retention shelf (v6.1) design

I could not get my hopper back on with the original model, so I increased the opening size.  The gaps for the retention allowed for the layer lines to more easily break (i.e., clips breaking off and wall separation).  The retention shelf design was redone to create more points of contact and less brittle shelf.

Prints shown were done in PETG, but PLA should work too and may even be better to prevent burr damage by allowing the outer tabs to break more easily.  I also use supports, but might try without on the next print.

Remixed from model by @Micha_241182