GoPro Hero 9 – 13 Battery Magazine for Air Travel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A storage container for GoPro Hero (9 – 13) batteries for use in air travel which complies with 49 CFR § 175.10(a)(18).
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 29
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
If you travel by commercial airline with spare lithium batteries, not only must they be carried in your carry-on only, but you also must protect them from damage and short circuit. This regulation is part of (in the U.S.) 49 CFR § 175.10(a)(18) and the specific part about spare lithium batteries reads:
"Spare lithium batteries must be carried in carry-on baggage only. Each installed or spare lithium battery must be of a type proven to meet the requirements of each test in the UN Manual of Tests and Criteria, Part III, Sub-section 38.3, and each spare lithium battery must be individually protected so as to prevent short circuits (e.g., by placement in original retail packaging, by otherwise insulating terminals by taping over exposed terminals, or placing each battery in a separate plastic bag or protective pouch)."
I used to put my spare GoPro batteries in individual plastic zip-lock bags when flying, which was a real pain, so I designed this GoPro battery "magazine" (storage container) as a much easier/convenient alternative to individual plastic bags. The magazine requires no additional hardware; it is 100% printable. It can hold up to four (4) spare GoPro Hero 9 – 13 Li-Ion batteries.
If you also have a GoPro Max2, you can find a version for spare Max2 batteries here.
Print Recommendations
0.4mm nozzle, 0.2mm layer height.
15% cubic infill.
Assembly
First, inspect the two parts to make sure there's no stringing, blobs, or other defects/artifacts that might interfere with the sliding latch; correct any of these issues before proceeding. Align the rails on the latch with the corresponding tracks on the magazine and begin sliding the latch into place until reaching the centrally-located positioning nubs on the latch piece. Using one hand to put pressure on the latch pulling against the nubs, use the other hand to pinch the upper portion of the latch, above the rail, in the area of the relief cuts adjacent to the nubs and on the opposite side of the nubs that's making contact with the magazine. Pinch inward until you are able to slide the latch past the nubs. Continue to slide the latch into position until you feel the positioning nubs click into the first position. This position is either the "unlocked" or "locked" position, depending on which end of the latch you started with. If it's "locked," push the latch into the opposite position to load your spare batteries into the magazine.

Change Log
10JUL2026: Added print file.