1 / 4
INDX Rear Filament Sensors Holder V2
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
INDX Rear Filament Sensors Holder V2
- Ocena
- 4,909 / 5
- Polubienia
- 74
- Pobrania
- 182
- Wydruki
- 13
- Wyświetlenia
- 2156
- Oceny
- 11
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Open Community License v1.1
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 13) (Komentarze: 35)Remiksy (3)Kolekcje (210)Powiązane
V2 of my rear filament sensor holder for the SpacePi rack. I was not happy with the first design, as it was sticking out too much at the back of the printer. This design is much slimmer and does not stick out more than the filtration system
For installation you will need:
4x M3x6 screw
6x M3x10 screw
5x M3 nylon nuts
PTFE tubes
On the screenshot you can see mounting points for top(1-4) and bottom(5-8) filament sensors
I also used Filament sensor Bowden adapter