Magnetic Swiss Point Dart Storage Case , DARTS

Magnetic Swiss Point Dart Storage Case (112 × 72 × 11 mm)

A compact magnetic storage case designed to keep your Swiss Point dart accessories organized and protected.

I created this case because I wanted something slim enough to fit inside larger dart cases while still keeping everything securely in place. The magnetic lid and magnetic compartments prevent items from moving around during transport.

Features

• 🧲 Magnetic lid for secure closure

• 🧲 Magnetic compartments to keep accessories in place

• 🎯 Holds Swiss Point dart points

• 🔧 Dedicated space for the Swiss Point tool

• 🪨 Storage for a sharpening stone

• 📏 Compact size: 112 × 11 × 72 mm

• 🎒 Fits easily inside most larger dart cases

• 🖨 Optimized for PLA printing

• 🔒 No rattling during transport

Important

Dart points shown in the photos are for demonstration purposes only and are NOT included.

The Swiss Point tool and sharpening stone are included in the design as dedicated storage locations.

Printing

• Material: PLA

• No supports required (recommended)

• 0.2 mm layer height

• 2-4 walls

• 15–20% infill

Notes

This is my own original design, created from scratch to provide a practical and compact storage solution for Swiss Point users.

If you print one, I'd love to see your make! Feedback and suggestions are always welcome.

Assembly Instructions

This model requires 6 magnets:

• 3 × Round Magnets: 5 × 2 mm

• 3 × Rectangular Magnets: 20 × 10 × 2 mm

Recommended magnets

Rectangular magnets (40 x 10 x 3mm):
https://amzn.to/4h7suG8

Round magnets (4 × 1 mm):
https://amzn.to/3Tu504d

Assembly

Use a small amount of super glue (CA glue) to secure the magnets.

• Insert the first round button magnet at layer 10.

• Insert the large rectangular magnet at layer 20.

• Insert the remaining three magnets at layer 38.

⚠ Important: Before gluing, always check the magnet polarity.

If a magnet is installed the wrong way around, the magnets will repel each other instead of attracting. This is simply due to the magnetic poles, so it's worth checking twice before applying glue.

Tip: Before gluing, stack the magnets together and mark one side with a permanent marker. This makes it much easier to keep the polarity consistent throughout the assembly.

Lid Hinge Assembly

The lid hinge is designed to use a single piece of filament as the hinge pin.

• Cut a straight piece of 1.75 mm printer filament slightly longer than the hinge.

• Slide the filament through the hinge holes.

• Trim the excess flush with the case, or melt the ends very slightly to prevent it from sliding out if desired.

This creates a simple, durable, and inexpensive hinge without requiring any additional hardware.

Tools:

Swiss point tool: https://amzn.to/4vXcR8V

Sharpener:https://amzn.to/4vXcR8V