Creator 5 Pro - Surf Pac Bento Box for Exhaust - HEPA and Carbon Filter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Surf Pac Bento Box for Exhaust - HEPA and Carbon Filter for Creator 5 Pro
- Ocena
- 5 / 5
- Polubienia
- 35
- Pobrania
- 142
- Wydruki
- 2
- Wyświetlenia
- 948
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Surf Pac Bento Box HEPA/Carbon Filter for Exhaust Fan of Creator 5 Pro.
You will need to take off the side of your C5P printer. See Flashforge Support YouTube channel to see how to do this. It is not very difficult, you will have to raise up your extruder holder assembly to make room for the side panel to come off.
The HEPA box is held to side panel with QTY 4 M3x8 screws and QTY 4 M3 heat sink inserts. The HEPA box is connected to the activated charcoal box with QTY 8 4mm x 2mm magnets.
You could probably print PLA for the Surf Pac Bento Box and it should be fine (not sure). I printed mine in ASA.
The HEPA filters are used in the orignal Bento Box design.
https://www.amazon.com/dp/B0782T7L6P?lv=shuf&channelId=751&ref_=cm_sw_r_cp_ud_dp_XYM6H4DT6QFP76PW8R2B&plpRedirect=mhFallback