Stallion wall mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall mount for the Stallion VTOL. Holds the plane vertically by the tail boom. Prints support-free, 3 screws.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 87
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Public Domain
Stallion Stable — VTOL Wall Mount
Stop leaving your Stallion on the floor. A VTOL fixed-wing with its wings, booms and props takes up an absurd amount of bench space — and every time you set it down, you risk crushing a prop, bending an antenna or stepping on it. This wall mount turns your plane into wall art: stored vertically, safely off the ground, and ready to grab for the next flight in seconds.
How it works
The mount grips the Stallion by its carbon tail boom — the strongest and most accessible point of the airframe — holding the aircraft nose-down (or tail-down, your choice) flat against the wall. No straps, no foam blocks, no pressure on wings or fuselage. The boom slides into the cradle, you insert the locking pin, and the plane isn't going anywhere until you want it to.
The parts (4 pieces)
SoportePared_A (main bracket): The structural core. Screws directly to the wall and features a dovetail slot that receives the locking system. All the load path goes straight into the wall anchors.
SoportePared_B (curved gusset): The elegant part. This curved brace triangulates the load, eliminating flex and letting the mount hold the full weight of the aircraft without creeping over time — important for PLA under constant load.
Pasador v2 (sliding pin): Slides through the bracket to close the cradle around the boom. Captive design — the boom can't jump out even if the plane gets bumped.
Seguro v2 (retainer clip): The safety. Locks the pin in place so vibration, curious hands or an accidental knock can't release your aircraft. Two-stage retention means zero chance of finding your Stallion on the floor.
Why you'll want it
Zero-stress storage: no load on wings, servos or control surfaces
One-hand operation: remove the clip, slide the pin, grab your plane — under 10 seconds
Print-friendly: all four parts print support-free in PLA or PETG
Cheap hardware: just two wall screws + anchors, nothing else to buy
Compact footprint: reclaims your entire workbench for building, not storing
Designed for the Stallion VTOL, but easily adaptable to any fixed-wing with a round tail boom. Print it, mount it, and give your aircraft the parking spot it deserves.