Disposable 75mm veggie can lid
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple can cover with grab ridge for preventing unused vegetables from drying out in the fridge
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 29
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
I opened a can of pumpkin, but couldn't find any can lids in the "stuff" drawer. 12 minutes later I had a can lid that fits a 74.5mm can ridge perfectly. This is the size of most standard soup-can / veggie cans in the grocery stores in the United States. It does not fit those squat little corn cans or cat food.
Very simple PETG print. May not work in PLA because PLA is too brittle. Import, Slice. Print. I used .2mm layer height, but that is just my default. Would work well at larger layer heights as well. I downloaded a model for a wide can of corn, shrunk it down and added a two sided lip to make it easier to pry off once in place. It's enough of a lid to keep the food from drying out.
As with all food related prints, do NOT believe this is a long term use item. The little air gaps between the filament can collect bacteria and that can be hard to eliminate if not impossible. Therefore, consider it to be disposable, one can use. If storing toys or something, its fine for long term use. It's even dishwasher safe so it would be fine for storing playdough.