Nespresso capsule wall holder with wider backing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Coffee capsule holder that trades some convenience features for better grip on the wall with sticky tape.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 80
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
I noticed some problems with the capsule holder sticking to the side of my kitchen cabinet with double-sided sticky tape. Therefore, I updated the original design to enable easier wall mounting.
Removed the internal sliding rail and instead enlarged the border around the hole in the middle to provide more surface area for tape.
Fused two lanes of the holder side-by-side for even more surface area in the middle and easier alignment when printing multiple lanes.
Removed the alignment dovetails, because they were causing problem with print tolerances. Instead, the new lower and upper parts are rigid enough to be easily aligned on the wall, so there is no need to join them before mounting.
The STL and 3MF files contain both the lower and upper part for two lanes of capsules. You can modify the FreeCAD assembly for a different arrangement of lanes to better fit your buildplate.
When mounting, make sure that the internal ramp of the upper part points up, i.e., allows the capsules to enter the lanes. The orientation of the upper part is otherwise unmarked.