1 / 3
Core ONE INDX Filament Sensor Mount Above Printer — zdjęcie 1
1 / 3

Core ONE INDX Filament Sensor Mount Above Printer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Bracket to hold the filament sensor upside down and hang from a shelf above the printer or mount to the wall

Ocena
0 / 5
Polubienia
9
Pobrania
6
Wydruki
0
Wyświetlenia
256
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This bracket holds the Core ONE INDX filament sensor upside down so the filament can be fed from above the printer. It can be mounted to the wall or under a shelf with the filament fed from dryers on the shelf above the printer. I printed mine using Atomic PETG and Overture High Speed TPU.  There are three lengths to choose from for the upper bracket. In addition, it has the following major features:

1) There is a PTFE tube clamp at the bottom to provide strain relief for the tubes going from the printer into the filament sensor.

2) The PTFE tubes from the dryers are held in place by ECAS fittings.

3) The gap above the filament sensor is open so that filament can be easily removed when the sensor detects out of filament.

4) The upper and lower portion of the bracket are held together by a bowtie joint with TPU plugs so they can be easily separated if you need to move the printer.

5) The upper bracket is held to the top mount by a dovetail joint with a TPU plug to hold it in place.

6) Requires a single size screw and nylon lock nuts.

Hardware:
     5 - M3x10mm screws
     5 - M3 Nylon Lock Nuts

Printed on an MK4S with the following settings:
     0.4mm nozzle
     0.2mm layer height
     2 perimeters
     5 top layers
     4 bottom layers
     15% infill
     Supports only used on the counterbore screw holes for Clamp B
    

Tagi