External Label for Prusa USS Drybox
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple label and filament sample that attaches to the outside of Prusa USS Drybox. No glue, no screws. Editable text.
- Ocena
- 5 / 5
- Polubienia
- 30
- Pobrania
- 79
- Wydruki
- 4
- Wyświetlenia
- 453
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
A simple label and filament sample that attaches to the outside of the Prusa USS Drybox. The label hooks onto one of the drybox clips without requiring the drybox to be open or affecting the seal.
The text is added in the slicer, so it is easily editable without modifying the model.
To install the label, simply unlock the clip and slide the label underneath it, then close the clip as usual. The label should not be squeezed by the seal of the drybox, it should just barely touch it from the side.
The thin section is designed to be three layers thick (at a 0.2 mm layer height). It fits under the drybox clip with minimal wobble while still allowing some movement to ensure the seal is not affected.
Tested with PETG, PLA, Woodfill and ASA, but any material should work. Prints in 3 minutes using 1.3 g of filament.