1 / 4
Shimano Alfine 11-speed adapters and mock sprockets — zdjęcie 1
1 / 4

Shimano Alfine 11-speed adapters and mock sprockets

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Installing Alfine 11-speed hub into horizontal Surly dropouts 12x142 / 12x148

Ocena
0 / 5
Polubienia
0
Pobrania
5
Wydruki
0
Wyświetlenia
47
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Public Domain

Dropout adapter model has 0.3 mm allowance for FDM shrinking! Not to be used directly for metal parts. I plan to add exact model for metal later.

While building bike on a Surly Karate Monkey frame, I needed to install Shimano Alfine 11-speed hub into rear dropouts. Shimano hub has 135 mm width and 9.5 mm diameter shaft. Karate Monkey frame has horizontal dropouts with Gnot-Boost spacing of 145 mm (bending slightly for both 142 and 148 mm standards) and 12 mm axle thickness. I mocked 5 mm symmetrical spacers and dialed in angle (-11.5°) so that gear shifter cable goes near chainstay -- so it does not interfere with chain. Photos of the result to be added.

I also made a mockup of hub sprocket with additional 3 mm shift outside to dial in chainline and make sure there is no interference with shifting cable. As well as chainring mockups to also check frame clearance. Modified sprocket to be made from two usual ones.

I've added dropout adapters design for CNC milling, however I personally did it on a manual mill and thus the design has not been tested. I spec-ed internal feature for 2 mm diameter endmill (1 mm radiuses). Resulting angle of shifter mechanism to frame can be seen on the photo. Washer is a must on the outside of dropouts.

Tagi