AEG/Electrolux Air Conditioner Oversized Hose Attachment
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This allows you to attach slightly bigger hoses than the stock 150mm one to AEG/Electrolux air conditioners
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 78
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- BSD License
I have an AEG Comfort 6000 air conditioner, and I wanted to upgrade it to a dual-hose setup using Rémy's mod. The problem I faced is that the hoses I bought from AliExpress wouldn't fit on either the original or a printed replacement. I suspect this is due to the expected method of attachment being different, with the typical connector going inside the hose instead of outside it. Alternatively, they may be six inch hoses, or it might be both. Either way, this model fixes it.
Before printing the entire thing, make sure it fits your hose! There are various ways of doing this, I'd suggest either scanning in the end of your hose, importing it into CAD software, scaling it to the right size, and comparing that way, or doing a test print of a small section. I have two hoses and this only comfortably fit one of them, although I could make the other one fit with a bit of persuasion. It's probably also worth checking the direction of the spiral on your hose at this point to make sure it's correct - if you do need to reverse it, set "left_handed" to false in the call to threaded_rod in oversized_hose.scad. If you need to increase the size, update pipe_diameter, also in oversized_hose.scad.
If your hoses are like mine, you might also need to peel off some reinforcement at the end and make it a spiral again.
Note that Printables is effectively forcing me to dual licence this, since they don't give the MIT licence as an option, but this is also licensed under the MIT Licence. See also: the Codeberg repo