Wire Bud - 18 to 22 AWG Wire Holders
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wire Bud - 18 to 22 awg wire holders - Holds wires in place
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 66
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Wire Buds
Printed in PETG and tested with 18 and 22 awg wire.
Found myself with too many ground and Positive wires hanging around prior to attaching them together so made this totally unnecessary gizmo to keep them neat and tidy until I'm ready to solder them all together. There's a Black Ground one, a Red Positive one and a plain one for future proofing. I'm new to electronics so no idea if these are useful to anyone other than me or if there is something else out there better that I've missed, but they made my project easier so thought I'd share.
Just push the wire through the bottom and out through the top which will add a little bit of grip to stop them falling back through and when your ready to join them all together just pull them out one by one and attach them together.
They are small at 9.2mm x 22.2 mm so make sure your print bed is clean and filament is dry, I got better print results using PETG and I used 0.12 layer height for better detail. Maybe slow the speed down a bit too.
