Iron Maiden Name Logo

Up the irons! This model is another entry in my Slave To The Metal 90s Drawing Series /Collection, where I am systematically turning my original hand-drawn concept art into clean, printable display pieces.

This plaque brings the legendary, aggressive, and razor-sharp typography of Iron Maiden to life. Because of the individual letter spacing of this iconic logo, this specific model is offered as a solid Base-only plaque to ensure the entire name prints perfectly as a single, sturdy piece. The base comes equipped with integrated keyhole slots on the back so you can effortlessly mount it flush against your wall!

Because the classic logo stretches quite wide in a single horizontal line, I designed this to sit right around an 8.2" text width to ensure an easy single-piece print for standard or smaller print beds.

Dimensions

• Text Width: 8.2”

• Text Height: 1.4”

• Text Thickness: 0.25”

• Text Inset: 0.0625”

• Base Width: 8.7”

• Base Height: 1.915”

• Base Thickness: 0.125”

• Total Thickness: 0.3953”

• Mounting: Features (2) built-in key-hole slots on the back of both the Base and No-Base variants for clean hanging with #3 screws or nails.

Print Settings

• Material: PLA

• Layer Height: 0.12mm to 0.20mm (Lower layer heights will make the sharp angular slopes of the letters look incredibly smooth).

• Infill: 10% or higher. (Gyroid or Grid patterns work beautifully for stability).

• Supports: None required when printed flat on the bed.

If you are looking for something taller to fill a specific wall gap, check out the companion listing here with vertically stacked "IRON" over "MAIDEN" text layout!

Where It All Began:

Want to see the original 90s pen-and-ink drawing that inspired this ongoing project? Check out the anchor model that started the series: