E14 lamp-base for "Buble Lamp shade" by @CarlosAceves_395508

This is a lamp base for the lampshade "Buble Lamp shade" by @CarlosAceves_395508.

Needed parts: 

• Printed parts: 

  • "Light diffusor"

  • "Attachment plate"

  • "Buble Lamp shade" by @CarlosAceves_395508 scaled according to the attached image

  • "Base"

• Other parts: 

  • 6x M4x12 screws

  • 6x 10mm round rubber feet

  • E14 lamp with a width less than 40mm

  • E14 lamp holder with a thread according to M24x2 

  • Power cord less than 6mm in diameter (to fit the groove at the bottom of the base)

Print settings: 

• Diffusor: 

  • Print in vase mode. 

  • Recommend a wall thickness of 1,2mm to fit in the groove on the base

• Attachment plate: 

  • Preferably a material which is a bit ductile such as PETG, otherwise it might be a bit tricky to get it inside the lamp-shade 

• Lamp shade: 

  • Download "Buble Lamp shade": @CarlosAceves_395508: https://www.printables.com/model/405441-buble-lamp-shade

  • Scale according to: (also seen in the attached image)

    • X: 36.41

    • Y: 36.41

    • Z: 78.32

  • Print in vase mode. 

  • 4 Bottom solid layers (important to get the “inner lip” the attachment plate can sandwich to the base). 

• Base: 

  • 3 walls

  • Layer height quite short (i used 0,15mm) so the threads are compatible with the lamp holder. 

Assembly

1. Pop the attachment plate inside the lamp-shade, make sure the protruding side of the attachment plate faces downwards and fits inside the solid-bottom layers of the lamp-shade. 

2. Assemble the base with the lamp, lamp holder, power cord and feet. 

3. Screw the attachment plate + lamp shade combo to the assembled base using the M4 screws

4. Snap the diffusor into the groove of the base