C5P (creator 5 pro) aux fan redirector.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
redirects aux fan down towards the filter for better circulation and filtration.
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 149
- Wydruki
- 2
- Wyświetlenia
- 804
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
After talking to a few people on reddit i can to realize that the aux fan is connected to the fresh air intake fan and can not be ran independently of that fan. the problem is if you want to filtrate your chamber, you have to run the aux fan, which can be a problem for materials that like less cooling during print. coincidently those materials are also the worst if not filtered properly.
printed mine in petg with .2 layer height with default tree supports in the orientation shown, and it took about 35 mins. cranked the aux fan up to 75% to test after popping it in and can confirm that it successfully pushes the air down away from the print bed and towards the filter, which after filtering it pushes it back up through the aux fan creating a circulation effect within the chamber. Should just pop right in the aux fan output and hold. Make sure when popping it into the fan outlet, that the legs are positioned so that they are surrounding the first peg on the grill (PROPER ORIENTATION IS SHOWN IN THE PICTURES FOR THE ITEM), if you put all the feet on both sides of the first peg it may break one of the legs and leave a gap on one side of the fan open.
PLEASE KEEP IN MIND that i am printing the supports with a pla interface so they come off clean, im assuming if you are printing stuff for the c5p you also have the means to do this.