Anycubic wash and cure (2.0) spinner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement spinner for the Anycubic wash and cure (2.0) tub.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 88
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
A replacement spinner for the Anycubic wash and cure (2.0) tub. I'd bet it will fit other tubs, but cannot confirm. The magnets in mine basically disintegrated, becoming unremovable. Another tub spinner was removable, so here are options.
The main tricks are that:
The center bearing is a 625ZZ.
The magnets are 3/4" Diameter x 3/16" Height, countersunk hole. I'm pretty sure that these are setup to be opposite polarity, so one may need to be flipped (if it just shakes, try that). If you have magnets ready to use, my included design might work for you. Alternatively, this design (that I found only after modelling) looks really good.
Also, check that everything spins before putting in your alcohol!
I printed in ABS, hopefully it can survive the alcohol for a while. I have some pre-supported options, because default supports will be awful to remove.
If your spinner can be taken apart, re-use what you can. Get proper disc magnets or use a substitute. Lot's of options here.