Toyota Hilux/Surf/4runner Gen2 Custom Centre Console

This is a custom 3d printable centre console for your Gen2 Hilux/Surf/4runner.

!Disclaimer!

this is based on a manual swapped R151F gearbox

Gearbox depicted and modelled around has had the transfer case shifter swapped with the A343F (automatic) transfer case shifter that is more vertical but is in a similar location so modification may or may not be needed

G52 or other gearbox's may need a modified top plate 

Photos depicts slight differences to models provided

Differences include:

custom switches (model provided is updated to suit standard off the shelf rocker switches)

Custom top plate (model provided extends the full distance with no gauge cluster)

Some other slight deference's may be present that addressed areas such as printability, assembly and other quality of life issues for assembly 

all mounting points are based off OEM mounts 

uses original arm rest

USB charger used is STEDI™ Short Nissan USB Pass Through

hardware required:

• gear shifter and transfer case stick boots: eBay universal boots

• 8x M3x12mm bolts are used for shifter boot

• 10x 8g x 15mm screws for supporting brackets 

• plastic glue of your choice 

• desired trim (trim to be glued to insert panels (thickness can range from 0.5 to 2mm)

postprocessing:

• spray filler primer

• plastic filler (raptor plastic filler worked well)

• desired paint for finish (bumper trim paint was used in photos to give textured finish)

1. gluing is only required for rear section to mid section

2. plastic primer was added to low spots and sanded flat

3. repeated 1-3 times until smooth

4. a even layer of spray filler primer to provide base coat (found this to be crucial for even top coat texture)

5. once dry apply desired paint for top coat

tip for assembly:

• when first installing screws (not including M3s) its best to heat screws to form the plastic to avoid cracking