Elegoo CC1 Canvas 5kg spool extension holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an extension for the Canvas holders that retain a 5kg 55mm spool.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 124
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Spool Collar has a small support that may need trimmed off from the hex side in order to slide in the slot on the Extensions smoothly.
For a low profile fit, there is the 5kg Extension. For a positive installation of the Spool Collar, there is a 5kg Extension with a hex handle on it to keep the spool holder from twisting when locking the Collar in place.
Adding supports to the grooves helps everything slide smooth. The holes for the screws do not need supports, they have support layers CADed into the model.
I frequently use the Sunlu 5kg spools, and after installing the Canvas system there was no good way to hold or mount the spools in my small print area. This Extension removes the outer cover of the Canvas spool mount and screws on in its place, then has a Collar that slots on over the extension to keep the spool from coming off. The upper spool mounts have enough room from the Canvas feed head to clear the spool, however the lower mounts are too close to the table without risers to clear. The spool mounts are too close together to mount all 4 with a large spool as well.
Installation:
Remove the sticker denoting what the spool number is.
Remove the 4 perimeter screws (#1 Philips bit) that are holding the factory cover on the spool holder.
Holding the extension with the mounting face up, insert the screws into the Extension and start them so they are just barely poking through. The holes are small enough that they will hold the screws while the extension is being installed.
Align the Extension onto the spool holder and start all 4 screws into the spool holder. Once all 4 screws are started and straight, tighten them all down. DO NOT OVERTIGHTEN! They do not need lot of force to secure onto the spool holder. I was able to install both Extensions with just a bit and a bit holder, no handle needed.
Install the sticker onto the Extension Cap. This may need glued on, depending on how cleanly it released from the factory spool cover.
Load the large spool on the spool extension.
Install the Collar.