1 / 5
UniFi G4 Doorbell Pro - Wallmount 45 degrees / Wandhalterung 45 Grad — zdjęcie 1
1 / 5

UniFi G4 Doorbell Pro - Wallmount 45 degrees / Wandhalterung 45 Grad

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Wallmount for UniFi G4 Doorbell Pro / Wandhalterung für UniFi G4 Doorbell Pro

Ocena
0 / 5
Polubienia
0
Pobrania
4
Wydruki
0
Wyświetlenia
30
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a wallmount for the UniFi G4 Doorbell Pro.

In my case the in needed a base plate to cover a whole in the wall and also a 45 degree mount to have a good view from the camera to my visitors in front of the door. Because i couldn't find a existing model which fulfilled both of my needs i created my own wallmount.

Printed in PETG with 15% infill and 3 walls. I recommend not to use PLA because normally the doorbell hangs outside.

The modell has a deeper plate in the top middle where you can add some text in the slicer. In my case there is the number of my house.

I also printed some of the surfaces with fuzzy skin. In the 3mf there is no fuzzy selected.

The only thing you need is two m3 heat inserts to fix the original metal plate from the doorbell to this wallmount.

 

Enjoy printing!

-------------------------------------------------------------------------------------------------------------------------------

Das ist eine Wandhalterung für die UniFi G4 Doorbell Pro.

In meinem Fall benötigte ich eine Halterung mit einer größeren Grundplatte um das Loch der Unterputzdose in der Wand zu überdecken und einen 45 Grad Winkel um mit der Kamera eine gute Sicht auf Besucher vor der Haustür zu haben. Weil ich kein Modell gefunden habe, dass beides erfüllte, habe ich ein eigenes kreiert.

Gedruckt in PETG mit 15% Infill und 3 Walls. Da die Klingel in der Regel draussen hängt, rate ich von PLA ab.

Oben in der Mitte der Grundplatte ist eine Vertiefung, in welcher man im Slicer bspw. einen Text einfügen kann - in meinem Fall die Hasunummer.

Ich habe einen Teil der Oberflächen fuzzy gedruckt, in der 3mf Datei sind aber keine Fuzzy Oberflächen vorselektiert.

Man benötigt noch 2 M3 Einschmelzgewinde, um die originale Metalgrundplatte der Doorbell auf dem Halter zu montieren.

 

Viel Spass beim Drucken!

Tagi