brushless coreless axial flux motor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
this is a axial flux motor that have been designing and developing to be a cool cheap 3d printable alternative motor
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 146
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Engineering
- Licencja
- Creative Commons — Attribution
this is a brushless axial flux motor with a 60mm rotor diameter designed for a mix of torque and rotational speed(exact benchmarks haven't been tested yet). This motor has 6 coils(2 coils per phase) and 6 magnet faces(uses 18 magnets total). I personal made the parts out of PETG and haven't run into to many issue but you could probably use PLA if you keep the amps down.
This motor has been designed for the use of 20 AWG enamel coated wire with 30 turns per coil.
REQUIRED RESOURCES:
20 AWG enamel coated wire
PETG filament
18 10mm by 3mm circular magnets(personally used n42 grade)
(use the picture to see assembly.)
comment any questions you have.