Supernote DIY Pen (Paper Mate Profile 1.4 Bold Point)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printable adapters to fit a Supernote refill inside a Paper Mate Profile 1.4 bold point pen body
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 45
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Changelog
2026-07-19: Added back the chamfer to the Spring Retainer that was accidentally removed before the release of the final version
Parts
Paper Mate Profile 1.4 bold point pen; you can get them in other stores too. I believe 0.7mm pens have the same body but not sure.
Preamble
Do NOT touch the coil. BE very careful when handling the refill.
Instructions
Print both parts, chamfer towards the bed.
Disassemble your pen (It screws off from the top). Save the spring; you can save the refill to swap into a spent pen.
Push the spring retainer (chamfer towards the tip) onto the refill past the internal spring. It should slide smoothly on the metal lower body. Then put in the spring and then the push the refill into the holder. It should be a bit snug. DO NOT GRAB THE REFILL BY THE COIL WHEN PUSHING IT INTO THE HOLDER!!! You can try to wedge your fingernail around the internal spring to get some leverage. Push it all the way down.
Put the Refill into the body and you're done. BE VERY CAREFULL TO NOT SNAG ON THE COIL!!!
