Radxa Zero 3W case with 4010 fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple but effective case.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 85
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
IMPORTANT!
If you have a non-eMMC model variant or going to use the microSD slot you MUST use V5 as earlier versions does NOT have hole for the microSD and will be unusable!
A two-piece, snap-fit printed enclosure for the Radxa Zero 3W with a 40 × 40 × 10 mm fan mounted inside, blowing straight down onto the SoC. No visible screws on the outside except the four countersunk fan screws, and no fan hanging off the side of the case.
Printing:
I have used PETG but PLA should be OK as well.
Print the stuff facing down. Supports are needed.
What you need:
1 x 4010 Fan
4 x M3x6 for the board
4 x M3x16 for the fan + washers optionally
The tray bosses are drilled 2.5 mm and are meant for thread-forming screws directly into plastic, no heat-set inserts.
Source
Board geometry from Radxa's official 3D model, radxa_zero_3w_3d.stp, available from the Radxa documentation download page. The SCAD file carries the measured values inline so you don't need the STEP to modify it.
Tools
AI help was used.
What's new in v4:
- Added toggle to turn off bottom vents
- Fan thickness is set to 15mm default to make it compatible with more fans (like Noctua NF-A4x10)
What's new in v5:
- Added hole for the microSD, so it's not only for the eMMC model anymore.
What's new in v6:
- Added hole for (RP-)SMA pigtail/external antenna.
(It is only available in taller variant as hole needs more taller wall)