Ball and Socket Mount that Fits Samsung EP-H5300 Car Charger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For a Samsung EP-H5300 car charger with a broken 17mm ball socket, this slots in as a replacement.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 53
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
What Is It?
If the ball socket on the back of your Samsung EP-H5300 car charger for Galaxy Flip and Fold broke off (mine broke in half), then this is a drop in replacement. The rear of the charger where the old socket fits in has a keyed surface, so I couldn't just snug up the flat base of an off-the-shelf socket and screw it down (also it would rotate), so I made a mounting plate that is keyed to the charger and fits snugly. The original screw that attached the original broken socket to the charger can be reused with this new mount.
Included STLs
The keyed mount plate connected to a threaded socket to fit a 17mm ball
The nut that fits that socket
The keyed mount plate by itself (if you want to mount the charger to something other than a 17mm ball)
Printing Instructions
The keyed mount plate w/ socket should print with the socket facing up. Because the keyed surface prints up against the build plate, some small amount of support is likely necessary. My print settings using an Elegoo Centauri Carbon are visible in the photos. I only used support (shown in green) for the middle of the part. I don't even know if this was strictly necessary, but it printed well and the support was easy to remove.
The nut should print with the threaded side facing up (i.e., with the shoulder of the nut flat against the build plate).
If printing the mount plate by itself (i.e., no socket attached), you should print with the keyed side facing up.
I printed this with PLA and I've never printed with any other material, so I'll update if something with more heat resistance is necessary after this lives in my hot car for a while.
Installation and Other Info
Orientation of the mounting plate on the charger matters! Note that the keyed surface of the mounting plate has three sections but one is very slightly different from the other two (circled in photo). The charger's keyed surface has a corresponding slightly different section, so line the two up together.
Be advised that the threaded socket and nut that I remixed for this fit very snugly on a standard 17mm ball.