10" Mini Rack 1U Blank Panel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Blank 1U filler panel for 10-inch mini racks. 12 variants: 6/4/2 mounting holes, reinforced and loose-fit versions.
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 60
- Wydruki
- 0
- Wyświetlenia
- 144
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
10-inch Rack 1U Blank Filler Panel — 6/4/2 Hole, Standard & Reinforced Variants
A blank 1U filler panel for 10-inch (mini/half) racks — covers unused rack units for a clean front and controlled airflow.
Mini racks are everywhere in homelabs now, but blank panels rarely come with the rack, and buying steel ones for a 10" rack is disproportionately expensive. This set covers the common mounting patterns and fit tolerances, so one of the 12 files should drop straight into your rack.
Features
Slotted mounting holes for alignment tolerance
Stiffening frame (reinforced versions) is 217 mm wide — sits well inside the 222.25 mm rack opening, with margin for racks that don't follow the spec exactly
Quick to print, no supports needed
Variants
Pick one file along three axes:
Axis | Options |
|---|---|
Mounting holes | 6 — all slots, default; 4 — corners only, cleaner look; 2 — central slot per ear, minimal mount |
Reinforcement | Standard — 3 mm flat; Reinforced — 3 mm panel with a 3 mm stiffening frame on the inner side, minimizes warping |
Fit | Standard — 254.0 × 44.45 mm (exact 10"/1U); Loose — 253.5 × 43.95 mm for racks with tight openings |
Example: 10in_1U_blank_4holes_reinforced_loose.stl = 4 corner holes, stiffening frame, loose fit.
Printing
Material: use your judgement — PLA is fine for a rack with no heat, PETG at minimum next to anything warm, and ABS/ASA if the neighboring gear runs hot
Layer height: 0.2 mm
Infill: anything — the panel isn't load-bearing
Supports: none — print flat on the front face (the filleted face on non-reinforced versions)
Hardware needed
Rack screws, quantity to taste — 2 is enough (1 can work, but expect it to sit slightly drunk); designed for standard M6 rack screws, but feel free to raid the screw drawer — just remember the slots are 6.5 mm
Fills the gaps in your 10" rack — pick the hole count and fit that matches, print, done.