1 / 5
Collapsible 1.4m Radio Telescope for 1420MHz Hydrogen Line Observations — zdjęcie 1
1 / 5

Collapsible 1.4m Radio Telescope for 1420MHz Hydrogen Line Observations

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A lightweight 1.4m radio telescope that uses an umbrella type design to support a parabolic dish made of EMF fabric.

Ocena
0 / 5
Polubienia
11
Pobrania
27
Wydruki
0
Wyświetlenia
215
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

My design was inspired by a radio telescope I saw that was made out of an umbrella style photographers light reflector. It was less than 1m in diameter and the EMF fabric was stuck on the inside. I thought it would be much neater (and a challenge) to design a larger version with a true parabolic shape and a purpose made EMF fabric cover.

The component parts were designed in the free (non-commercial) version of Autodesk Fusion (the Fusion Archive is in the files). Most parts were printed in PETG-CF with just the wave guide and clamp nuts printed in basic PETG. The ribs were too large to fit on my Bambu A1 build plate so these are printed in 3 parts and then glued using 2 part epoxy glue. The ribs are printed on their back such the print layers are in compression for strength. A layer of 2mm sticky backed neoprene foam is stuck to each rib to prevent the abrasive PETG-CF wearing through the EMF fabric. 

I made a paper template for cutting out the EMF fabric leaving 20mm margins for the seam. The radial seems were double sewn. There are eye holes at the outer end of each rub and 3mm shock cord is pass through these and the outer hem of the fabric crossing over at each rib to keep the fabric taught across the top of the ribs. 3mm shock cord is also used to secure the fabric at the central hub. There is a layout sketch in the fusion assembly for the cutting the fabric.

I have included a shopping list spreadsheet showing where I sourced the bit needed. I have also uploaded the .3mf files as there were left following the last print for the individual components.