Mestic MCC-35 MCC-25 Removable Fridge Basket (Compressor Fridge Box 35liter or 25liter)

This insert basket is designed for the Mestic MCC-35 and MCC-25 compressor fridge.

The basket follows the tapered shape of the fridge’s inner walls.
Approximate Dimensions
Bottom: 325 × 246 mm
Top: 331 × 253 mm
Total height including the bottom risers: approximately 250 mm

It keeps food, bottles and other contents away from the inner walls and the bottom of the fridge. This helps prevent the contents from touching condensation or water that may collect inside the fridge and also improves air circulation around the stored items.

There are three different versions included:

1 ) Full-height version – 2 parts:
This version consists of two identical parts.

Print the same part twice and connect both parts together.
................................................................................

2) Full-height version – 4 parts:
This version is intended for smaller 3D printers.

Print:
2 × normal parts
2 × mirrored parts
................................................................................

3) Reduced-height version – 4 parts
This version is also intended for smaller 3D printers but has a reduced overall height.

Print:
2 × normal parts
2 × mirrored parts
................................................................................

Assembly

The basket sections are connected using:
M3 nuts
M3 × 8 mm socket-head screws

Risers must be attached underneath the basket. These lift the basket above any water or condensation at the bottom of the fridge.

The risers can be mounted using M3 nuts and one of the following screw types:
M3 × 6 mm socket-head screws
M3 × 6 mm button-head screws
M3 x 8 mm socked-head screws
M3 x 8 mm button-head screws

The number of risers can be selected depending on the expected load and the required support. I used 30 risers for my basket.
................................................................................

I printed in PET-G, but also PLA will be fine.
No support needed.